In addition to change filters, there's very little you can do to keep within your CPAP machine clean and hygienic. Over time, they begin to accumulate dust and other small particles, which is the time to become a fertile ground for bacteria. How to show the images on this page, inside a CPAP machine can become very dirty. Is unavoidable as a result of what they do – suck in the air and therefore also everything that is lingering in the air will come with it. While a filter will keep out of the majority, it cannot keep 100% of particles.
The comparison would be easier to make a computer. If you open it up for the first time in a while, you will find many of the components will be covered in dust sucked my fans. A CPAP machine is no different and similarly, having a circuit board inside, that is a magnet for dust. This powder bacteria can hide and breed. Consequently, some then will find its way into your airflow, tubing, the mask and your lungs.
If the introduction to this post sounds alarmist, which is why it is we all CPAP users to be aware that dust and bacteria accumulate inside their machines over time and, therefore, be vigilant about preventing and dealing with it regularly. The first step is obvious, but often overlooked: clean and change the filters.
Almost all manufacturers recommend cleaning and changing their filters regularly. For example, Respironics recommend cleaning the coarse filter every two weeks and replaced by a new in six months. It is very important to do so, as dirty or worn filters will not be effective in blocking particles and bacteria entering the system.
The second step to take is to sterilize your CPAP machine. Because you do not have permission to open it correctly, it is clear that the best next step is simply to esteriliza it. Most users regularly will clear your CPAP mask and hose, which is highly recommended, but this work is then hampered by dirty air blowing machine straight back to them.
CPAP Guardian bags provides back with an ozone sterilizer built-in. you simply put your machine in the bag, and the Guardian CPAP fills with gas ozone – an who kills all living organisms. However, after about 30 minutes the particles ozone disintegrate in regular oxygen, leaving without harmful gas or waste but a CPAP machine completely barren. You can use it to disinfect the entire system at once, including his mask and tubes.
Many people choose to keep your CPAP on the floor. to reduce noise, reduce condensation in the mask or simply not enough space on a bedside cabinet. However, if you CPAP is on the ground he inevitably going to suck more dust and dirt. If your floor is wooden, laminated or carpet it will house more dust and bacteria than a table. If you CPAP machine must be reduced, see if you can find a booth to elevate it a few inches from the ground. After all, the first prototype CPAP was done with a vacuum cleaner motor, so they have some serious suction and will pull any microbes in the surrounding area.
Keeping your CPAP as clean as possible is vital for the prevention of health problems caused by him. Try to keep your CPAP off the ground to minimize the amount of dust that sucks it and ensure that clean and replace filters on your machine, as recommended by the manufacturer. Following these two simple steps you will considerably reduce the amount of microbes entering your system the first time.
However, over time it is inevitable that some will accumulate however careful you are. We recommend, therefore, getting your machine sterile to ensure that it is harbouring any bacteria. CPAP Guardian bags provide Method the most effective and safe to do so today, and have the added advantage of making a big travel bag for your system as well. In General, do everything you can to ensure that the air supply to remain clean and safe and make sure you stay as healthy as possible in the process.
沒有留言:
張貼留言